Installation Tips
Very Important
The cartridges must be adjusted as much as
possible.
When a hole has to be drilled for the housing of
the cartridge, the following factors should be noted:
 |
The inside of
the drilled hole must be uniform, without gralings, nor
different diameters however small they might be. Finishing
off with a reamer is recommended. |
|
|
The heat rises. |
|
|
The
distribution is greater at the ends and the heat is
concentrated in the middle. |
|
|
Choosing
cartridges from stock: comprising 8 to 11 wcm2. |
|
|
Ensure that the
drill hole has an outlet as to make removal easier. |
|
|
The connections
must never be inside the drilled hole, as there is the risk
of crossing and burning. |
|
|
The connection
must be protected to prevent possible spilling of fluids and
the entry of plastic, gases, etc. |
|
|
The
microporation of a sounding is recommended and must have a
maximum distance of 15mm from the cartridge and be connected
to a temperature regulator. |
|
|
There must be a
minimum space of 3 diameters between the cartridges.
|
 Extraction
As far as a hole must be drilled at one end of the connection so
that the cartridge may be expanded more easily. The most suitable
paste can be found on the market for easier removal and best
conductivity (the paste must not be in contact with the
connections).
Physical
characteristics of solids
|
Material |
p
|
Melting |
Cp
|
Cf
|
| Steel |
7.8 |
1400 |
0.12 |
60 |
| Aluminium |
2.7 |
600 |
0.23 |
94 |
| Bronz |
78.4 |
900 |
0.10 |
|
| Smelting |
4.2 |
1150 |
0.13 |
30 |
| Stainless Stell |
7.8 |
1600 |
0.12 |
56 |
Example of heating a cutting blade
Call us
now to discuss your needs.
|
